logo
Most Viewed Last 7 Days
436MHz DATV Up-Converter (483)
DVB-S USB rx (133)
Archive3 - DATV Software (119)
13cm Amplifier (70)
ATV Dx Gallery (63)
ATV Contest 2005 (63)

Analogue vs Digital



    Cluster Activity

    Spots per uW band today:
    UK spotter or spotted only.

    Solar data:
    SFI
    76
    A-Index
    6
    K-Index
    2
    Exp.K
    2
    Sunspots
    26
    Activity
    qui
    GMF
    qui
    Aurora?
    no

    My Weather

    Date:18/11/17 Time:17:36
    Temp:3C
    Wind Speed:0mph
    Wind Dir:202deg
    Pressure:1017.28mB
    Humidity:118%
    Dew Point:6.6C
    UKHASnet
    Analogue vs Digital

    Here are the results from a few tests I did in 2011

    Here we have some tests done at 4Ms Digital vs analogue quality...

    With 4Ms 1/2 i set the power level so i could access GB3KM with a small margin, i then switched over to Analogue and set the same power level as the digital was.

    Here is the result:

    Analogue



    Digital 4Ms 1/2 with same power as Analogue




    I also tested the difference in power level between a locked signal at 1/2 FEC and then 7/8 FEC, the result was ~4dB difference. According to the specifications for DVB-S the actual number is meant to be 4.4dB so that is close enough for me!



    When going down to 1Ms at 1/2 the signal to noise will increase another 6dB compared with 4Ms 1/2, so if we drop the power from the above test by another 6dB on the analogue transmission we get this signal level at the repeater... quite weak, where as a 1Ms 1/2 digital signal would be in lock.

    Analogue 6dB lower signal



    It just shows how well the lower symbol rates can get through compared with analogue!

    The digital receiver at GB3KM is a Comag SL-35, the analogue receiver is a Standard Continental with IF Bandwidth at 16MHz i believe.
    Both are driven with ~35dB gain Bob Platts type preamp tuned for a center frequency of 1280MHz.











    Last page added:16/08/17 15:45
    M0DTS.co.uk