logo

Cluster Activity

Spots per uW band today:
UK spotter or spotted only.

Solar data:
SFI
178
A-Index
7
K-Index
1
Exp.K
3
Sunspots
103
Activity
eru
GMF
qui
Aurora?
no

My Weather

ArrayDate:07/12/24 Time:12:04
Temp:7C
Wind Speed:15mph
Wind Dir:270deg
Pressure:987.29mB
Humidity:118%
Dew Point:10.6C
DSG 13Z Lathe

A little different project this time....

We have had a lathe in the shed for around 15 years which has not been used. It has been there since it was was moved from the old workshop in 2004 where it was used for odd jobs.
It's a Dean Smith & Grace Minor lathe (13Z) - The only documentation i have been able to get hold of is here
I'm getting it up and running in anticipation of some metalwork jobs for Ghz bands along with the now 'little' CNC mill!

Here's the photo from the shed, needs a bit of TLC!

DSG 13Z



I've now moved it to a tidier shed to work on which has main to operate it, but that's another story...

It was pretty much covered in old oil/grease and swarf and needed a shovel to dig all that out.
The grease has had a protecting effect in some cases but a lot of rust on the sliders, chuck and tail stock.
With a fair bit of Paraffin it has been cleaned down to something resembling a lathe, but also showed that it needs some work to make anything which needs any precision!

DSG 13Z cleaned



Here's the cross slide lead screw, there's about 3/4 turn of slack so rather worn but hopefully i can do something about that!

Cross slide lead screw



All parts have been free'd off and oiled so it's now functional apart from the motor drive.
It uses a 3HP Single Phase motor, after tracing down some earth leakage to the starter caps case vs motor case it still would not start from the mains in the shed, it just draws too much current at start up...

I have managed to get it to run from a 10kva generator but only just, the starter box was chattering for ages before it fired up so not the ideal solution!
I have decided to buy a 3 phase motor and inverter to allow me to do a 'soft' start which should overcome the volt drop on the cable and allow the motor to run nicely, it also allows me to reverse the motor/drive if required in the future.

Lets hope this does the trick, otherwise i'm stuck without any drive!!

....








Last page added:25/03/00 18:32
M0DTS.co.uk